Basically you need to send 'break' while its booting, my laptop doesnt have a break key but FN + B should work no worries but doesn't, Ive tried another keyboard with a break key and even right click on Putty and send special command 'break' and no go. I am awaiting your arrival Cisco Freak. Cisco Break Sequence for Outgoing Telnet and SSH Sessions by Scott Hebert There are a few network devices out there that allow you to connect, but don't give you an option to disconnect.

• Putty Send Break Cisco
• Putty Break Sequence Cisco
• Putty Serial Break Sequence Cisco Download
• Break Sequence Cisco Router
• Securecrt Break Sequence Cisco

A friend of mine ran into a strange issue doing a password recovery. His new laptop was missing the break key. I have also heard of issues using those usb to serial adapters sending a break sequence. In his case, he was using a usb to serial adapter and had a laptop missing the break key. The solution below worked for him.

Here is the complete article:

but steps are:

How to Simulate a Break Key Sequence

Putty Send Break Cisco

Break key sequence simulation is useful if your terminal emulator does not support the break key, or if a bug does not allow your terminal emulator to send the correct signal.

Note: The hyperterminal under Windows NT had this behavior in the past.

(11.17 MB) John Fahey Hard Time Empty Bottle Blues (1 4) EP (2003) Source title: john fahey zip download - mediafire search - (1 - 10 from 25 files) (81.33 MB) john fahey God, Time and Causality Source title: John Fahey Oil - RapidShareMix - Search for Shared Files (57.34 MB) 063 Skip James Hard Time Killing Floor Blues (1964)[By ribbon] Source title: 063.

Putty Break Sequence Cisco

Complete these steps to simulate a break key sequence:

1. Connect to the router with these terminal settings:

1200 baud rate

No parity

8 data bits

Putty Serial Break Sequence Cisco Download

1 stop bit

No flow control

You no longer see any output on your screen, and this is normal.

2. Power cycle (switch off and then on) the router and press the SPACEBAR for 10-15 seconds in order to generate a signal similar to the break sequence.

Break Sequence Cisco Router

3. Disconnect your terminal, and reconnect with a 9600 baud rate. You enter the ROM Monitor mode.

Securecrt Break Sequence Cisco

If all these methods fail to properly send a break, retry the procedures from a different terminal or PC platform